V250 Series

Vacuum Switch with Overpressure Protection to 3000 PSI 0.5-29.5" Hg range

This series is a sturdy miniature vacuum switch for high pressure applications. This model allows sensitive, accurate, set point in vacuum, while having the ability to withstand high pressure surges and spikes to 3000 PSI.

Features:

• Stainless Steel Construction
• Sensitive Limp Diaphragm
• Miniature Size
• Excellent Accuracy and Repeatability
• Field Adjustable or Factory Set, or Factory Set and Locked
• 4000 PSI Proof

Specifications:

NON-WETTED MATERIALS

• Body-300 series stainless steel.
• Lock ring-steel, zinc chromate finish.
• Electric switch housing-steel, zinc chromate finish.
• Actuator - steel.
• Springs - steel.
• Plastic parts-nylon or PVC.
• Adjusting Nut - steel.

WETTED MATERIALS

• Fitting-300 series stainless steel.
• Adaptor - 300 series stainless steel.
• Seal-O-Ring-Standard BUNA N (optional-EPR, Viton, Silicone, Neoprene, and other exotics).
• Diaphragm - Kapton.
• Locking Compound-Loctite #277.
• Washer - 300 series stainless steel.
• Screw - 300 series stainless steel.

VACUUM SWITCH ADJUSTMENT (if field adjustable)

A change in the set point may be made by turning the adjusting ring located in the opening in the side of the body. Causing the ring to turn counter clockwise will raise the set point, and turning clockwise will lower the set point. For the best results after ressing the switch, cycle the system pressure level several times to stabilize the new set point. Repeat above procedure if necessary.

SETTING OPTIONS

Switches are normally supplied field adjustable, may be ordered factory set, or factory set and locked.

TEMPERATURE RANGE

-65° F to +225° F, a slight change up to 2% in the set point may occur below -10° F and above +125° F.

CYCLE RATE-SENSOR AND ELECTRICAL SWITCH

Not to exceed 22 CPM (cycles per minute).

WEIGHT

Approximately 5 ounces (with a standard 'W3' interface).

PRESSURE CONNECTION

1/8-NPT male standard.

V250 SERIES PERFORMANCE TABLE

AVAILABLE FITTINGS

The fitting types below are "standard catalog" offerings. Some of the fittings below are available only for an additional cost. If you do not see your preferred fitting listed, please contact our Sales Department as we do offer custom fittings.

AVAILABLE ELECTRICAL INTERFACES

The electrical terminations below are "standard catalog" offerings. For our "W" and "L" styled interfaces we have an exhaustive listing of Pin/Connector terminators from such makers as AMP, Molex, Turk, Bendix, Cannon, Burndy and others available to make our product ready for your specific application.